V: 1.0 Revised: May. 2019
40
Chapter 6: AcuLink 810 User interface
By default the WIFI mode is set for Access Point Mode, where the AcuLink 810 acts as a wire-
less bridge allowing other wireless devices to connect.
6.10.2 Ethernet 1
The Ethernet 1 settings can be configured by selecting the 'Ethernet 1' tab on the Network
Configurations page.
• Interface Status:
Tells users whether there is an Ethernet cable connected or discon-
nected to the Ethernet 1 port.
• DHCP:
Select 'Manual' to manually configure the IP address for Ethernet 1. If set to
'Manual', users will also need to set the Subnet Mask and Gateway. Select 'Auto' to have
the AcuLink 810 assigned an IP address automatically. With this selection the Subnet
Mask, Gateway and will also be automatically assigned.
• IP:
If the DHCP is configured to Manual, the IP address can be configured.
• Subnet:
If the DHCP is configured to Manual, the Subnet Mask can be configured.
• Gateway:
If the DHCP is configured to Manual, the Gateway can be configured.
www.
.com
information@itm.com
1.800.561.8187