V: 1.0 Revised: May. 2019
45
Chapter 6: AcuLink 810 User interface
6.14 Data Logging
The AcuLink 810 supports data logging to its internal memory, which has 8GB of memory.
When the memory is full the oldest data logs will be overwritten. To configure the AcuLink
810 to log the meter data click on 'Data Log' under the 'CONFIGURATION' menu on the left
navigation panel.
AcuLink 810 supports at most 3 data loggers, the data log for each logger can be pushed to
the post channel or saved in its internal memory.
• Data Log Enable:
Select 'Enabled' to enable the data log
• Post Channel:
Select the Post Channel from the drop down list:
• None:
AcuLink 810 will log and store the data on its memory
•
Post Channel 1/2/3: AcuLink 810 will log and push the data to the configured post
channel. Users will not be able to select the post channel if it is disabled.
NOTE:
For more information on configuring the Upload Protocol refer to the 'Post Chan
-
nels' section of the user manual.
Once all settings are entered in correctly, click on 'Save'. Users can use the 'Test Post
Channel' button to determine whether the 810 can reach the FTP server.
NOTE:
If users receive a fail message, please verify the server URL, port number, user-
name, password and double check the network connectivity.
www.
.com
information@itm.com
1.800.561.8187