6
* lf you are not going to use the unit for a long period of time (approximately three months
or more), remove the batteries.
* Replace worn batteries with their polarities in the correct direction.
TIME AND VOICE ON/OFF OF SYSTEM SETUP
1. Press the
“SET” key to turn on.
2. Press and hold the
“SET” key until the year number displays and flashes
on LCD to enter the settings mode.
3. Press the
“MEM” key to adjust the year, then press the “SET” key again to
save your setting and enter the month setting mode.
4.
Press the
“MEM” key to adjust the month. Following the same steps to
adjust date/hour/minute/(Voice on/off) until the setting is
completed (“
” is
On, “
” is the Off) Non-talking model does not have this function, or you may choose
method No.2 to set the voice.
Method No.2 for voice setting: Please press and hold the
“MEM” button when the device is in
the shutdown state to enter the voice setting. P
lease press the “MEM” button again to choose
“ON” or “OF”. Press the “ON/OFF” button to quit.
UNIT CONVERSION mmHg/kPa DISPLAY
The monitor has two kinds of blood pressure display units mm Hg(mmHg), kPa (kPa). (mmHg
is the factory default). While the monitor is off, press and
hold the ON/OFF button for 5 seconds. The monitor will
boot up and measure showing the other unit. (If it was in
mmHG it will change to kPa and vice versa.) Also the
stored values will be shown in the new unit.
