13
13
8)
8) T
To connect the load with the UPS, please turn of
o connect the load with the UPS, please turn off all the loads
f all the loads
first, then perform the connection and finally turn on the loads
first, then perform the connection and finally turn on the loads
one by one.
one by one.
9)
9) No matter the
No matter the UPS is connected
UPS is connected to the utility power
to the utility power or not, the
or not, the
output of the UPS may have electricity. The parts inside the unit
output of the UPS may have electricity. The parts inside the unit
may still have hazardous voltage after turning off the UPS. To
may still have hazardous voltage after turning off the UPS. To
make the UPS have no output, power off the UPS, and then
make the UPS have no output, power off the UPS, and then
disconnect the utility power supply.
disconnect the utility power supply.
10)
10) Suggest
Suggest charging
charging the batteri
the batteries
es for
for 8
8 hours before
hours before use. After
use. After
connection, turn the input breaker in the “ON” position, the UPS
connection, turn the input breaker in the “ON” position, the UPS
will c
will charge the batteries automati
harge the batteries automatically
cally. Y
. You can also
ou can also use the UPS
use the UPS
immediately without charging the batteries first, but the backup
immediately without charging the batteries first, but the backup
time may be less than the standard value.
time may be less than the standard value.
1
11)
1) If i
If it is
t is necessary to
necessary to connect the
connect the inductance l
inductance load such
oad such as a
as a
monitor or a laser printer to the UPS, the start-up power should
monitor or a laser printer to the UPS, the start-up power should
be used for calculating the capacity of the UPS, as its start-up
be used for calculating the capacity of the UPS, as its start-up
power consumption is too big when it is started.
power consumption is too big when it is started.
Important notes: If the UPS is used in single mode, JPI and JP2 must
Important notes: If the UPS is used in single mode, JPI and JP2 must
be connected by
be connected by 10A
10AWG(6mm
WG(6mm
2
2
). If the UPS is used in parallel mode,
). If the UPS is used in parallel mode,
JP1 and JP2 must be disconnected.
JP1 and JP2 must be disconnected.
Input and output
Input and output T
Terminal Block
erminal Block wiring diagram
wiring diagram of TN26000(S)/TN2-10000(S)
of TN26000(S)/TN2-10000(S)