36
36
11. Setting by LCD Module
11. Setting by LCD Module
The output voltage rating and frequency rating and bypass state could
The output voltage rating and frequency rating and bypass state could
be set directly through LCD Display. The output voltage rating could be
be set directly through LCD Display. The output voltage rating could be
set to
set to 208V
208V, 220V
, 220V, 230V and
, 230V and 240V
240V. The output
. The output frequency rati
frequency rating could
ng could be
be
set to 50Hz and 60Hz. The bypass state could be set to enable and
set to 50Hz and 60Hz. The bypass state could be set to enable and
disable. But all the settings could only be done when the UPS is in
disable. But all the settings could only be done when the UPS is in
Bypass or No Output mode.
Bypass or No Output mode.
In Bypass or No Output mode, pres
In Bypass or No Output mode, press the Select button on
s the Select button on the LCD panel
the LCD panel
for more than one second, a flickering black round dot would be shown
for more than one second, a flickering black round dot would be shown
in the front of “208V” on the screen. And if press the Select button
in the front of “208V” on the screen. And if press the Select button
continuously again, the flickering black round dot would move to the
continuously again, the flickering black round dot would move to the
front of “220V”, next to the front of “230V”, “240V”, “50Hz”, “60Hz”,
front of “220V”, next to the front of “230V”, “240V”, “50Hz”, “60Hz”,
“Bypass Disable”, “Bypass Enable” in turn. And if press the Enter button
“Bypass Disable”, “Bypass Enable” in turn. And if press the Enter button
for more than one second at this time, the flickering black round dot
for more than one second at this time, the flickering black round dot
would turn to flicker less and the output voltage rating or frequency
would turn to flicker less and the output voltage rating or frequency
rating or bypass state setting would be modified to the selected value.
rating or bypass state setting would be modified to the selected value.
And if no any pressing on the Select or Enter button lasting for more
And if no any pressing on the Select or Enter button lasting for more
than ten seconds, the flickering black round dot would disappear, no
than ten seconds, the flickering black round dot would disappear, no
setting have be modified.
setting have be modified.
The only one voltage rating could be selected in “208V”, “220V”, “230V”,
The only one voltage rating could be selected in “208V”, “220V”, “230V”,
“240V” at any time, only one frequency rating could be selected in
“240V” at any time, only one frequency rating could be selected in
“50Hz”, “60Hz” at any time, and the output voltage and frequency would
“50Hz”, “60Hz” at any time, and the output voltage and frequency would
be changed to the corresponding value after turning on the UPS by
be changed to the corresponding value after turning on the UPS by
pressing the ON button.
pressing the ON button.
The UPS would turn into Bypass mode in several seconds after “Bypass
The UPS would turn into Bypass mode in several seconds after “Bypass
Enable” is selected, and turn into No Output mode in several seconds
Enable” is selected, and turn into No Output mode in several seconds
after “Bypass Disable” is selected.
after “Bypass Disable” is selected.
Here is a example for changing the output voltage from 220Vac to
Here is a example for changing the output voltage from 220Vac to
230V
230Vac through th
ac through the LCD panel.
e LCD panel.