28
8. Troubleshooting
IMPORTANT!
The troubleshooting chart covers most of the difficulties that you may encounter
under normal working conditions. If the UPS fails to operate properly, please review
the following steps before contacting the service center.
TROUBLE SHOOTING CHART
SYMPTOMS
POSSIBLE CAUSES
ACTIONS TO TAKE
UPS can not be turned ON
UPS is not connecting to
AC and overloaded
Please conect to AC and
reduce the load
The imput fuse is burnt or
breaker is off
Replace the fuse or reset
the breaker, remove some
load and check if the load
is short-circuit or faulty
AC Input voltage is too low
Please check the AC Input
voltage
The UPS is failure
Please send to the agency
to repair
The red LED continuous
bright with beep every
8 seconds
UPS suddenly turns to
battery mode in spite of
utility line present
Save the data promptly
and shut down the
operating system
The red LED continuous
bright with a beep every
1 second
Back-up time less than
1 minute
Close the system and
recharge again
Back-up time less than
specified
Overloaded
Please reduce the load
Battery is not fully charged
Recharge the battery for
atleast 12 hours and reset
the backup time
Carging unit fault
Please send to agency to
repair
Summary of Contents for FLUX 850
