In the Stroke Measurement mode, the duration of 3 strokes is taken and the stroke frequency (counts per
minute) is calculated. As the stroke frequency falls out of the range of 10 - 180, "Err" will appear to show the
error condition.
Press [START] to start the measurement. During the 1st second, 180.0 will be shown and flashing as below.
At the end of the first second, the display will become steady.
If measurement is stopped in the first second (stroke frequency > 180), error signal " Err " will be shown. After
the first second has elapsed, the instantaneous measurement reading will be shown. When you press [STOP],
the display will show the steady stroke measurement reading. If the measurement lasts for more than 18
seconds (stroke frequency < 10), an error signal "Err" will be displayed. When the measurement is stopped,
press [RESET] to reset the displayed reading to "0.0".
Speed Mode (AE760M100 & AE790M500 Model only)
Press [MODE] until you enter the Speed mode. The display will be as follows.
(Note that the default setting is KM. Hence "KM" icon will be ON.)
The upper line shows the distance or speed. The lap time is in the middle line, while the total time is displayed
on the lower line.
In the Speed mode, you can record a number of lap times and speeds for covering the distance you program
into the chronograph.. Before starting to use the Speed mode, you need to enter the distance as explained
below. Otherwise, the speed measurement won't work.
S T R O k E
1 8 0 . 0
0. 0 0 0
0: 00' 00"
00
0: 00' 00"
00
LAP
STOP
{000}
DIST KM
15
