background image

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer 

onto your belt or the top edge of your pants or skirt. It should 

fit snugly and level, above one knee. 

Note:

 The pedometer should be as vertical as possible. 

Walkers with larger stomachs may find it helpful to wear the 

pedometer farther back on the body, toward one hip. 

To avoid losing or dropping your pedometer, use the included 

leash and clip to fasten the pedometer securely to your 

clothing. 

Attaching the Leash: 

Attach the pedometer to the leash by 

looping the leash around the pedometer belt clip. Next, clasp 

the waistband of your clothing with the attached clip. You can 

also use a safety pin to fasten the leash to your clothing, loop 

the leash through your belt or belt loop, or use a badge holder. 

VIEWING YOUR RESULTS

Once you put on your pedometer, it will automatically begin 

to record your steps. Press the DAY button to view today’s 

step count. Press the TOTAL button to view total steps taken.

MEMORY PEDOMETER

OPERATING INSTRUCTIONS

ACCUSPLIT, Inc.  •  2290M Ringwood Ave.  •  San Jose, CA 95131

800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •   www.ACCUSPLIT.com   •  support@ACCUSPLIT.com

ACCUSPLIT®

       EAGLE

 

1120M2

Eat Right!  Walk More!  Live Well! 

The ACCUSPLIT Lifestyle

Congratulations on taking the first step to wellness with your purchase of an ACCUSPLIT 

pedometer. It’s easy to set up your new pedometer. Just follow the steps below, and start walking!

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily.  

To reset: While displaying Day’s Steps, press and hold DAY 

button for at least three seconds to reset to zero. When  

displaying Total Steps, press TOTAL button for three seconds 

 

to reset Total and Day’s Steps to zero.
AUTO MOVEMENT SENSOR

1. To filter out random movements, the unit remains in standby 

 

  mode until 5 continuous steps are registered. Only then are  

  the 5 steps calculated in, and an Active indicator “

” appears  

  on the upper left of display.

2. When regular walk/run movement stops, after 2 seconds the 

 

  timer pauses and the unit switches to standby status (Active 

 

  indicator “

” disappears). 

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to replace 

the battery. Your pedometer uses one Type L1142 (LR43) 1.5 

volt silver oxide battery. To replace:
1. Using a jeweler’s screwdriver, loosen small  screw on back of 

 

  unit. Remove back of case.
2. Slide the old battery gently out of its holder. Replace it with a 

 

  new battery. The battery’s positive (+) terminal should be 

 

  FACE UP while you put it into the pedometer.

3. Gently press front and back of pedometer  case back together,  

  being sure to line up slots and tabs at top and bottom of unit.

ACCUSPLIT

EAGLE

1 1 2 0 M 2

T W 1 5 M G

T

O

T

A

L

D
A
Y

AccuSTEP

10000.org

ST

TL

MODES

•   “D”– “Day’s Steps”

  Counts steps taken since last RESET.

•  “T”–”Total Steps”

  Keeps track of all steps taken, even after  

  Day’s Steps are reset.

DAY button

TOTAL button

970-043

First, loop the 

pedometer clip

Next, loop the metal 

clip, then clasp clothing

Or, loop a  

badge holder, then 

 put into pocket

(Badge holder  

not included)

Or, loop a belt  

or belt loop

REGISTER NOW

 

Please return 

your AE1120M2 Registration to 
the Repair Center address in the 
warranty, and we will let you 
know about future products. 

Email (preferred)
User

Reviews: