36-37
36
37
Note: You cannot delete all segments while the
stopwatch is running. If nothing happens when
you push and hold [STOP • RESET] check to
make sure the stopwatch is stopped.
Timer Mode
Press [MODE] until you enter the Timer mode.
3 count-down operation modes are available on
this stopwatch:
• Count down repeat (CR)
• Count down stop (CS)
• Count down, then count up (CU)
The timer is set at the factory to the count-down
repeat (CR) mode. At entering timer mode, the
mode message “TIMER” will be shown for a sec-
ond before timer count mode is displayed.
38-39
38
39
The upper line shows the programmable timer
value (initially set at 0:00:00:0) while the middle
line displays the current timer counting. Time of
Day clock display is at the lower line of the dis-
play. “CR” indicates the current timer operating
mode while the timer cycle counter is located at
the upper left of the display.
Before starting the timer, enter a countdown time
fi rst. Then press [START • SPLIT] to start timer
running. When the timer counts down to zero, a
3 second “beep…beep” sound will be generated
for a timer setting within one minute; 15 second
“beep…beep” sound for 1 minute to 10 minutes
setting and 30 second “beep…beep” sound for
over 10 minutes. Pressing any key will stop the
beep sound.
Under CR operating mode,
the timer value will
be reloaded and count down will start again. The
timer cycle counter will be increased by one and
updated on the display.
Under CS operating mode,
the timer, after count-
ing down to 0:00’00”, will stay at 0:00’00”0 until you
press [STOP • RESET] to reload the timer value.
Under CU operating mode,
the timer, after
counting down to 0:00’00”0, will count up and
stop at 19:59’59”9.
Time in Countdown
Repeat mode
Time of day
Number of cycles
Timer setting
Elapsed time
