background image

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer 

onto your belt or the top edge of your pants or skirt. It should fit 

snugly and level, above one knee. 

Note:

 The pedometer should be as vertical as possible. Walkers 

with larger stomachs may find it helpful to wear the pedometer 

farther back on the body, toward one hip. 

To avoid losing or dropping your pedometer, use the included 

leash and clip to fasten the pedometer securely to your clothing. 

Attaching the Leash: 

Attach the pedometer to the leash by 

looping the leash around the pedometer belt clip. Next, clasp 

the waist-band of your clothing with the attached clip. You can 

also use a safety pin to fasten the leash to your clothing, loop 

the leash through your belt or belt loop or use a badge holder. 

OPERATING INSTRUCTIONS

ACCUSPLIT, Inc.  •  3090 Independence Drive, Suite 148  •  Livermore, CA 94551

925-290-1900  •  800-935-1996  •  FAX 925-290-1930  •  www.ACCUSPLIT.com  •  support@ACCUSPLIT.com

ACCUSPLIT®

       EAGLE

 

1120

Eat Right!  Walk More!  Live Well!  The ACCUSPLIT Lifestyle

Congratulations on taking the first step to wellness with your purchase of an 

ACCUSPLIT pedometer. It’s easy to set up your new pedometer. 

Just follow the steps below, and start walking!

RESETTING YOUR PEDOMETER

Most people prefer to reset step counts daily. To reset:  

Press and hold RESET button for at least three seconds to  

reset to zero. 

AUTO MOVEMENT SENSOR

1. To filter out random movements, the unit remains in standby  

  mode until 5 continuous steps are registered. Only then are  

  the 5 steps calculated in, and an Active indicator “

” 

  appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds the  

  timer pauses and the unit switches to standby status (Active  

  indicator “

” disappears). 

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to 

replace the battery. Your pedometer uses one Type L1142 

(LR43) 1.5 volt battery. To replace: 

1. Using a jeweler’s screwdriver, loosen small screw  

  on back of unit. Remove back of case.
2. Slide the old battery gently out of its holder. Replace it with  

  a new battery. The battery’s positive (+) terminal should be  

  FACE UP while you put it into the pedometer.
3. Gently press front and back of pedometer case back  

  together, being sure to line up slots and tabs at top and  

  bottom of unit.
4. Replace the screw snugly, but gently.
5. Perform a RESET function, pressing RESET button for  

  3 seconds.

ACCUSPLIT

AccuSTEP

10000.org

STEP

TW15MG

1 1 2 0

EAGLE

RESET

VIEWING YOUR RESULTS

Once you put on your pedometer, it will automatically begin to 

record your steps. 

970-042vB

First, loop the 

pedometer clip

Next, loop the metal 

clip, then clasp clothing

Or, loop a  

badge holder, then 

 put into pocket

(Badge holder  

not included)

Or, loop a belt or belt loop

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

Refurbish, repair-or-replace service before 10/1/10, $5 fee; After 10/1/10, 

service may not be available. Return with fee and day phone # to:  

AST Repair Center/970-1010, 2290M Ringwood Ave., San Jose, CA 95131

REGISTER NOW

 

Please return 

your AE1120 Registration to the 
Repair Center address in the 
warranty, and we will let you 
know about future products. 

Email (preferred)
User

Reviews: