18
19
16
17
20
21
22
23
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it
will automatically begin to record your steps and activity
time. Repeatedly press the MODE button to cycle through the
pedometer modes:
STEPS
g
TIME
g
STEPS
Activity time is counted automatically whenever steps are
being counted.
• TIME is time spent in step activity.
Note:
For extra accuracy, the default Step Filter Setting is 1.
See page 21 to learn more.
GOAL TRACKING
As discussed in beginning of instructions, this unit keeps
track of your progress towards the Step and Time goals you
set. Progress is shown as a series of small bars appearing
on the bottom of the display, with each bar representing
5% of the total. For example, if you set your step goal to
4,000 steps, and you’ve walked 2,000 steps so far, the goal
indicator in STEP mode will show as 50% complete. Progress
towards each goal is shown on the corresponding screen
– for example, when viewing TIME, you will see both the time
traveled in hours and minutes, and also the progress towards
your time goal on the bottom of the display.
RESETTING YOUR PEDOMETER
Most people prefer to reset counts daily. To reset your
counts: From STEP or TIME mode, press and hold the yellow
RESET button for at least 2 seconds. You’ll see the values all
go back to zero.
OTHER SETTINGS
The Step Filter setting is accessed through a special “deep
set” mode.
To enter this mode, press and hold the S1 (SET) button for
4 seconds. The screen will display a flashing single digit.
CHANGING STEP FILTER SETTING
While the JW200 PedometerEngine™ Step Sensor is
extremely accurate, some people like to have the ability to
filter out false steps. Therefore, the unit has a variable setting
step filter, to allow fine-tuning to your specific preferences.
You can set the value to any value from 0 – 5 steps. For
example, if the filter is set to “3”, the unit will wait to start
counting steps until more than three steps have been taken in
less than five seconds.
Press S3+ (MODE) or S3– (RESET) to change the step filter
setting. Press and hold S4 (SET) for 2 seconds to exit Deep
Set Mode.
Note:
The unit will save any changes and exit set mode after
30 seconds unattended.
Set Step Filter set point
STEP TIME SET
80
60
40
20
0
100%
D
IGI
-
W
ALKER
XL
.COM
120
XL
G
S3-
S3+
S1,S2,S4
JW200
MY
GOAL
Can be set
from 0-5
steps
REPLACING THE BATTERY AND MASTER RESET
When the display starts to dim or goes blank, it is time to
replace the battery.
If the display is not uniformly dim or blank, and appears to
display “erroneous data”, do a Master Reset by pressing all
3 buttons simultaneously for 3 seconds and then release.
The display should go blank, then turn all segments on, then
display 0 steps in Step Mode.
Note:
All the settings will return to their default setting values.
If you need to change the battery, the settings will also revert
to default settings.
Battery
First, loop leash
through slot on side
of pedomete
r
Next, clasp clothing
Or, loop a badge
holder, then
put into pocket
(Badge holder
not included)
Or, loop a belt
or belt loop
To replace the battery:
1. Insert a coin into the slot on the
bottom of the case, and twist to
loosen the faceplate. Remove
faceplate and set aside.
2. Locate the battery holder as seen
on sketch. Pull out the old battery,
and push a new LR-44 battery into the holder,
with positive terminal (+) facing up.
3. Snap faceplate back into place, hooking the bottom
two tabs first, then closing by pressing together at the
top two tabs.
