5
Carefully store the transportation packaging for the possibility of further use. If you have a claim on the warranty,
always use the original packaging for any necessary transportation. Transportation without this packaging can lead
to damage to the housing.
Please check, if the following items are included:
1 x AC mains cable (type depends on your country)
2 x replacement fuses for
FUSE 1 / FUSE 2
(type depends on your mains voltage)
Provided there is available space the power amplifier should, if possible be positioned as close as possible to the
loudspeakers since the loss within the loudspeaker cable is generally higher than with interconnect cables.
Therefore always use the shortest possible loudspeaker cable but of equal length on the left and right side.
Due to these facts and due to its high weight the power amplifier is usually set up in a position near to the floor
either between or near the loudspeakers. If you cannot set up the power amplifier in a free position, then under
no circumstances should the chimney effect of the heat sinks be restricted. Therefore leave a minimum of 5 cm
distance at the sides and 10 cm distance above the housing cover. Take care that the base of the power amplifier is
always stable and level.
Please
do not
put any other electronic products (e.g. preamplifier, CD player, turntable etc.) directly on the AMP II
–
MK 3, instead please use a suitable hifi-rack.
VERY
IMPORTANT!
CAUTION ! DANGER OF FIRE !
Please never cover the ventilation slots or the heatsinks.
This could lead to overheating of the power amplifier and cause serious damage or fire.
Please never put any other electronic products or other objects directly on the AMP III
–
MK 2.
Fig. 1 Distance to walls and objects
