ACCUSYS, INC.
5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C.
TITLE
EXPERAID COMMAND LINE INTERFACE USER GUIDE
PROJECT
“DESKTOP RAID”
DOCUMENT STATUS
OFFICIAL RELEASE
REV.
G–05-NOV-2007
PAGE
13
OF 27
3.3.1.4
Command Name
Command Description
SetPassword
Use this command to set password of the active controller.
Parameter 1
Parameter Description
Password:
<CHARS>
Password:
CHARS must be an 8-character alphabetic string.
3.3.1.5
Command Name
Command Description
CtrlName
Use this command to set controller name of the active controller.
Parameter 1
Parameter Description
Controller Name:
CHARS may not exceed 16 characters.
Example
Controller Name:
<CHARS>
CLI>CtrlName Ctrl1 [Enter]
The controller name will be set to ‘Ctrl1’. If the number of characters
in parameter 1 is more than 16, the additional characters will be
ignored.
3.3.1.6
Command Name
Command Description
RunScript
Use this command to run CLI commands from a pre-written script file.
Parameter 1
Parameter Description
File Path:
Specify an existing script file(FileName) located in the specified
directory.
Example(Under Linux environment)
File Path:
<[DIR] <FileName>>
CLI> RunScript /tmp/script1 [Enter]
CLI will start to run commands written in the script file ‘script1’
3.3.1.7
Command Name
Command Description
Use this command to quit CLI command line interface.
Parameter Description
Exit
N/A