AccuTemp STX-AT-EK, Instructions Manual

- 7 -

3.  Once the temperature has been achieved the base will beep 5 times, 

the base heating element will automatically turn off, and the red LED 

will turn off. 

4.  Whenever you remove the kettle from the plugged-in base it will turn 

off. This is a safety feature to eliminate the potential for electrical 

shock or fire with an exposed hot base.

NOTES:

• 

You can cancel the selected temperature at any time by pressing 

the selected temperature button again. This will shut off the base.

• 

Fog and condensation will appear in lid and water level view, this is 

typical.

• 

You cannot select a lower temperature once the kettle has heated 

to a designated setting until after it has had time to cool down.

•  When heating water to the highest temperature (212˚F), the kettle 

may vibrate slightly on the base. This is expected.

KEEP WARM MODE

The Enhanced Keep Warm Mode is designed to allow the kettle to 

maintain a designated temperature for up to 30 minutes. During this 

mode, each time the kettle is removed and replaced, the kettle will be 

reheated to the designated temperature. During this mode the kettle 

base will beep for 10 seconds each time the kettle is removed from the 

base and beep once when it is replaced. It will automatically reheat to 

the designated temperature. This mode will be maintained for up to 30 

minutes. After approximately 30 minutes the base will automatically turn 

off.

1.  Fill the kettle as directed (see FILLING THE KETTLE).

2.  Place the kettle on the base.

3.  Select the desired setting by pressing AND HOLDING one of the six 

buttons for 3 seconds. It will beep three times and the button LED 

will light up red while the kettle is heating. Once the kettle reaches 

the designated temperature, the kettle will beep once and the LED 

will change to blinking blue to indicate the Enhanced Keep Warm 

Mode is functioning.