[ inspiring people, inspiring change ]
Installation
Installation
G. Pairing Wireless Headset with Telephone
First of all, before proceeding to pairing
the headset, make sure the rechargeable
battery has been installed within the
headset. If not, carefully remove the
battery cover and connect it to the battery
cable connector inside. Follow the
instructions on previous section for help.
Then with the headset firmly sitting inside
the base-station,
.
charge a full 4 hours
before the first use
H. Registering/Pairing Headset to Base Station
The reason why we need to pair the
headset to the telephone is because
different telephones have different
settings and pin-alignments for their
handsets.
To pair, put on your headset and press
the Answer Button
on the headset
for the lifter to uplift the handset, or
manually pick up the handset if you
don’t have a lifter.
(2)
If you hear a dial tone, the wireless
headset works with your telephone.
But if you do not hear a dial tone, pair
the two by sliding the
until you hear a dial-tone.
Configuration
Switch
(14)
2
First Charge - 4h
14
Once you hear a dial-tone, make a call
using your telephone. If the person on
the other end hears you perfectly, the
pairing is completed.
If you hear the caller, but s/he cannot
hear you or the volume is very low,
slide the
,
until you find the best setting. Out of
the 7 possible combinations, there may
be more than one optimal setting.
(14)
Configuration Switches
11
Your wireless headset should
already be paired with the base
station, but in case it hasn’t or if the
headset are un-paired for some
reason, press the
for 5 seconds until
the LED indicator on the base
station flashes.
Then quickly press the
or 3
seconds until its LED indicator
flashes RED/BLUE. The headset is
paired when both LED indicators
are off.
(11)
(5)
Pairing/
Register Button
Mute
Button on the headset f
WT99 WIRELESS TELEPHONE HEADSET
your true wireless handsfree office solution!
11
12
12
