Window-Raiser: OPTIONAL
This is an
option
.
Make sure that the hole in the cylinder axis corresponds to the first hole in the tube.
Push the smallest pin with its straight rod through the holes. Make sure that the pin sticks through the tube.
Turn the cylinder completely in the round nut.
First disassemble the roof window; then, disassemble the crossbeam.
Slide 2 stop bolts in the bolt slot of the crossbeam.
Reinstall the crossbeam. Make sure that the crossbeam is pressed completely against the glass. Then reinstall the rubber on the
crossbeam and have it fit closely to the side that is cut off diagonally.
The numbers of the detailed views indicate the assembly order. Tighten the assembly definitively.
Install the base plate firmly on the crossbeam with the two pre-mounted bolts.
Reinstall the roof window in its place and centre it.
Clamp the window-raiser base plate on the roof window tongue, using 2 bolts and a stainless steel plate.
Turning the cylinder determines the opening distance of the roof window at a specific temperature.
Additional Advice and Tips
-
Insurance: it is recommended to inform your insurance broker on the installation of your greenhouse.
-
Regularly check
o
whether all bolts are still tightened
o
whether the anchors (concrete and anchors) are still intact
o
the position of the roof window
-
Extra checks in times of bad weather
o
Make sure that the window-raiser is locked in the hole and firmly clamps the roof window.
o
Make sure that the door is firmly closed; if possible, lock it.
o
Make sure there are no air splits under the foundation.
o
During winter, remove snow from the greenhouse (weight).
-
General rule: Make sure that the wind cannot enter your greenhouse.
-
Tips for a good functioning of your greenhouse
o
Regularly clean the gutters
o
Regularly clean the condensation water gutters
o
Clean the door threshold profile for smooth functioning of the door
o
Regularly oil the wheels of the door for a smooth functioning
o
Clean the glass
- Automatic window-raiser: during the winter period, remove the cylinder, oil it and store it in a warm place. You can always use the
manual window-raiser. Do
not
use the automatic window-raiser and the manual window-raiser together.
Q
Summary of Contents for S3 H
