9/
2
8
/20
22
ACE130
13
Heatsink and Processor
Location: The processor is found on the motherboard underneath the heatsink fan. Refer to
Figure 1 for additional guidance. The FORCE 12 motherboard only accepts a single processor.
Type and number of fastenings:
Heatsink: 4x Philips screws
Processor: Carriage mechanism
Tools required: Philips PH2 screwdriver
Procedure:
Heatsink with Philips screws
Step 1: Ensure the desktop is off, unplugged, and any potential energy is dissipated.
Step 2: Remove the side panel from the chassis as indicated in the “Chassis Cover” section of this
manual.
Step 3: Remove 4x Phillips screws from the
base of the heatsink module. Once all 4
Phillips screws are removed you will be able to
remove the heatsink module off the processor
socket.
Step 4: The heatsink is powered by the
motherboard, so the cable connecting the
heatsink to the motherboard will also need to
be disconnected. Follow the cable from the
origination on the heatsink, back to the
motherboard. You may have to remove the zip
tie mechanisms securing the cabling along the
way for successful removal.
Reinstallation
Step 5: Align the heatsink with the mounting holes and reinsert the Philips screws in the locations
noted in the photo, do not over tighten the screws.
Step 6: Connect fan cable to fan header on motherboard.
