Table 4 – User message displayed in Device Screen
User Action
Message displayed on
Device screen
Description
REC
No of REC
Number of records saved in Device Memory
SEND
Records Uploaded
Total number of records uploaded in Server
SEND
Total Records
Total number of records saved in Device Memory
SEND
No Pending Records
This message will appear if all the records in Device Memory
have been sent to Server
Table 5 – Admin Menu Items and Description
Sl.No Menu Item
Description
1
SET TIME&DATE
To set the current Time and Date
2
SET CARD TIMEOUT
Timeout interval after location ID is captured through RFID scan by User. If
set to 5 seconds, the Device will display the location ID for 5 seconds soon
after the Location Tag is scanned. After the timeout, the user must scan
the Location Tag again for successful recording.
3
VIEW IMEI NUMBER To view device IMEI number
4
SET CO2 OFFSET
To set the offset for CO2 Sensor. To be used only under senior technician's
presence
5
POWER SAVE TIME
Time out for Backlit to save power while in battery
6
VIEW RECORDS
To view the recorded data present in Device memory
7
DELETE RECORDS
To delete all the records in the device memory. [Separate Password
protection]
8
EXIT
Exit the Admin Setting screen
Instructions – For Recording
1.
Use the On/Off Switch to turn on the Instrument. Once the Instrument is switched on,
it displays information as per
Table 2
above
2.
Check the Battery status if the device is sufficiently charged. If single bar is blinking
continuously, please charge the device. [Refer
Battery Care Section
for charging
instruction]
3.
Use the RFID scanner of the device to scan the location ID(RFID) Card. The
Instrument will display the location ID on screen.
4.
When the location ID is displayed in screen, press the ‘REC’ Button to save the
current data displaying in the device. The message in screen will display ‘No of REC’
i.e. number of records saved in the device memory.
Page 2
