Chapter
6 Monitoring and Diagnostics
Installation and Operation Manual
6-98
Recovering ACE Units
ACE-3105, ACE-3205 Ver. 5.2
Rx Correct frames
... (643666)
Rx Correct bytes
... (189088942)
Tx Correct frames
... (643763)
Tx Correct bytes
... (189097238)
Rx FCS errors
... (0)
Rx Congestion dropped
... (0)
4.
Check that the transmitting device is not losing any packets due to transmit
congestion events that are eventually reported as missing packets on the
receiving device.
5.
Go to Monitoring>Applications>Multiservice over PSN>PW>Statistics.
TX congestion dropped ... (0)
TX timeout
... (0)
6.
Reduce the throughput of the transmitted traffic to help minimize the packet
loss events caused by BW/congestions on the network.
•
Reducing the overall transmitted throughput will always cause an increase of
the delay.
•
All changes must be performed on both units simultaneously.
•
Service will be unavailable until both the receiving and the transmitting devices
are properly configured.
³
To access the max cells concatenation parameter (ATM):
•
Go to Configuration>Applications>Multiservice over PSN>PW>Service
parameters.
1. MAX cells concatenation[1 - 29]
... (1)
2. Timeout mode
> (Enable)
3. PW timeout (usec) [100 - 5000000]
... (100)
³
To access the payload size parameter (TDM):
•
Go to Configuration>Applications>Multiservice over PSN>PW>Service
parameters.
1. payload size (frames in packet)[2 - 256] ... (8)
payload size (bytes)
... (248)
With regard to packet loss, check the following:
Note
