Chapter
2 Installation and Setup
Installation and Operation Manual
2-4
Connecting to DSL Network Equipment
ACE-3105, ACE-3205 Ver. 5.2
³
To connect the unbalanced E1 interface:
1.
Connect the RJ-45 connector of the adapter cable to the RJ-45 port
designated E1.
2.
Connect the transmit cable to the red coaxial connector of the adapter cable
marked "
→
" (see
3.
Connect the receive cable to the green coaxial connector of the adapter cable
marked "
←
" (see
Figure
2-3. RJ-45 to 2BNC Adapter Cable
2.5
Connecting to DSL Network Equipment
The DSL ports can be used to efficiently receive/transmit pseudowire traffic over
PSN. Ethernet interfaces can also be used to receive and for inband management
access. in addition to inband-management.
Using DSL Interfaces
DSL interfaces enable cellular backhauling over IP DSLAM. DSL interfaces interface
terminate in an 8-pin RJ-45 connector.
ACE-3105 ships with SHDSL or ADSL2+ interfaces. It is not available with both
DSL interface types.
³
To connect the ADSL2+ interface:
1.
Connect standard straight UTP cables to the RJ-45 connector of the Ethernet
port designated ADSL1 or ADSL2.
2.
Connect the other end of the cable to a DSLAM connected to the PSN.
Figure
2-4. ACE-3105 - ADSL2+ Ports
Note
