Chapter
4 Configuration
Installation and Operation Manual
4-10
Configuring for Management
ACE-3105, ACE-3205 Ver. 5.2
³
To access the Manager List menu:
•
From the Management menu (see
), select Manager list.
The Manager List menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> System> Management> Manager list
1. IP address ... (172.17.140.201)
2. Trap mask
> (Manual)
3. Traps
>
>
Please select item (1 to 3)
ESC-previous menu; !-main menu; &-exit
Figure
4-9. Manager List Menu
Table
4-7. Manager List Menu Parameters
Parameter Description
Possible
Values
IP address
The manager’s IP address.
Note:
•
The manager's IP address cannot be
the same as the subnet of an existing
host, unless it is attached to it.
•
Multicast, broadcast, all ones and all
zeros IPs are not allowed.
•
Address parts that are not subnet
cannot be all zeros or all ones.
•
The manager's IP address cannot be
changed dynamically (on-the-fly)
0.0.0.0 –
255.255.255.255
Trap mask
Manually enable/disable mask on a
specific alarm, or enable/disable all alarm
traps in a single operation.
•
All masked – all traps
are masked
•
None masked – No
trap is masked
•
Manual – masking is
manually configured
on the Traps menu
Default: Manual
Traps
Provides access to traps configuration
menu.
Note: This parameter is visible only if a
manager is already defined and the trap
mask is set to Manual.
Refer to
and
Up to 16 managers (management IPs) can be defined per unit.
Note
