Installation and Operation Manual
Chapter
4 Configuration
ACE-3105, ACE-3205 Ver. 5.2
Configuring for Management 4-27
3.
From the Trap menu, configure the following:
Trap name – Select a trap to be assigned to the selected notification
Notify Name – Select a tag from the list of previously defined notification
tags.
By default, traps are assigned to a Notify name which is identical to the trap
name. Deleting existing assignments may impede proper functionality.
Configuring the Target Parameters
A target is a network management station to which ACE-3105, ACE-3205 should
send trap notifications over SNMPv3. A set of parameters must be configured and
assigned to each target. Then, each target must have a valid IP address and IP
mask. In addition, a previously configured parameter set and notification tags
must be assigned to the target.
³
To configure target parameters:
1.
From the SNMPv3 Settings menu, select Targets & Notify.
The Targets & Notify menu is displayed.
2.
Select Target Parameters (“Target Params”).
The Target Parameters menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> System> Management> SNMPv3 Settings> Target& Notify>
Target Params
1. Name ... ()
2. Message Processing Model > ()
3. Security Model > ()
4. Security Name ... ()
5. Security Level > ()
>
Please select item <1 to 5>
B – Back; F - Forward
ESC-prev.menu; !-main menu; &-exit
Figure
4-22. Target Parameters Menu
Table
4-19. Target Parameters
Parameter Description
Possible
Values
Name
An ASCII string identifying current set of target
parameters. Enter the name of a new target or
use the B and F keys to browse through the
targets.
Up to 32 alphanumeric
characters
Caution
