Chapter
4 Configuration
Installation and Operation Manual
4-36
Configuring for Management
ACE-3105, ACE-3205 Ver. 5.2
Table
4-25. Summer Time – Date Mode Parameters
Parameter Description
Possible
Values
Start date
[YYYY-MM-DD]
The specific date (year-specific) on which
the daylight saving time begins
0001-01-01 to
9999-12-31
Start time
[HH:MM]
The specific time (hour and minute) at
which the daylight saving time begins
00:00 – 23:59
End date
[YYYY-MM-DD]
The specific date (year-specific) on which
the daylight saving time ends. The end date
cannot precede or be the same as the start
date.
0001-01-01 to
9999-12-31
End time
[HH:MM]
The specific time (hour and minute) at
which the daylight saving time ends, on the
end date
00:00 – 23:59
Offset (minutes)
The fixed number of minutes that should be
added to the local time during the daylight
saving time period
0–720
Default: 60
Setting the Syslog Parameters
Once the date and time are set, system events are logged accordingly. To allow
logging/sharing of system events on a server instead of internally, you need to
configure the Syslog server parameters.
³
To access the Syslog server options:
•
From the System menu (see
), select Syslog.
The Syslog menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> System> Syslog
1. Logging status > (Enabled)
2. Server IP address > (190.72.140.100)
3. Server UDP port > (514)
4. Device UDP port > (514)
5. Facility > (Local 1)
6. Severity level > (Minor)
>
Please select item <1 to 6>
ESC-Previous menu; !-Main menu; &-Exit
Figure
4-31. Syslog Menu
