Chapter
4 Configuration
Installation and Operation Manual
4-46
Configuring for Operation
ACE-3105, ACE-3205 Ver. 5.2
Parameter Description
Possible
Values
Scrambler
ATM cell payload scrambling mode.
The Scrambler cannot be changed for a link in
an IMA group.
Note: Unavailable in CES-ATM/CES-PSN modes.
Enable
Disable
Default: Disable
Mode
The mode in which the T1 interface operates:
UNI or IMA.
T1-UNI
T1-IMA
CES-ATM
CES-PSN
Default: T1-UNI
OAM cell
generation
Generation of ATM OAM cells in case of
physical layer failure.
Note: OAM cell generation is available in UNI
mode only.
Enable
Disable
Default: Disable
Failure alarm
The type of alarm that is generated in case of
TDM or PSN failure.
Visible only in the CES-PSN mode and when the
line type is ESF.
Note: If the line type is 'Unframed', the failure
alarm type is always AIS.
Trunk condition
AIS
Default:
Trunk condition
Trunk condition
The data pattern by which the CENoPSN or
CESoATM bundle is conditioned. This is the
byte code that is transmitted over CES
allocated timeslots upon underflow/overflow,
far-end LOS or AIS alarms.
Note: Visible if the failure alarm is set to Trunk
condition (also see the note below).
00 – FF (hex)
Default: FF
•
The Trunk Condition parameter is available only:
In CES-PSN mode when the line type is CRC enabled/CRC disabled and
the failure alarm type is set on 'Trunk condition'.
In CES-ATM mode when the line type is CRC enabled/CRC disabled.
•
The Trunk Condition parameter cannot be changed when:
An ATM CES connection exists in CES-ATM mode.
A PW of type 'Basic CES PSN' is attached to this port.
Configuring the ADSL2+ Ports
The ADSL2+ ports in ACE-3105, ACE-3205 are used for cellular backhaul over or
DSLAM structures and transmission of HSDPA data over ADSL2/ADSL2+.
ACE-3105 ships either with ADSL2+ or SHDSL ports (as ordered). ADSL2+ options
are not available if ACE-3105 is equipped with SHDSL ports.
Note
Note
