Chapter
4 Configuration
Installation and Operation Manual
4-80
Configuring for Operation
ACE-3105, ACE-3205 Ver. 5.2
Parameter Description
Possible
Values
•
IMA groups are available only for SHDSL.
•
The port/group number cannot be changed
dynamically (on the fly).
1–5/9/17
VPI The
channel’s
VPI
Note:
•
AAL5 VCL with the same VPI as an existing VC
XC cannot be configured on the same port.
•
The VPI cannot be changed dynamically (on the
fly).
0–255
(if ACE configured as UNI,
max VPI bits = 8)
0–4095
(if ACE configured as NNI,
max VPI bits = 12)
VCI
The channel’s VCI. For VP XC.
Note:
•
AAL5 VCL with the same VPI/VCI as an existing
VC XC cannot be configured on the same port.
•
The VCI cannot be changed dynamically (on the
fly).
32–65535
Out TD
The channel's traffic descriptor.
Note:
•
The traffic descriptor must be created first.
•
The traffic descriptor can be changed on the fly
as long as it belongs to the same service
category. The traffic descriptor’s PCR cannot be
higher than the output rate.
•
TD with service category of CBR-CES cannot be
used.
•
TD mode cannot be used with Policing.
1–99999
Default: 1
OD
The CES channel's OAM descriptor.
Note:
•
The OAM descriptor must be created first.
•
OAM descriptor cannot be changed on the fly.
•
The max number of Endpoints (Vcl/Vpl) with OD
with OAM Loopback ‘On’ is 128.
1–256
Default: 1
