Chapter
4 Configuration
Installation and Operation Manual
4-94
Configuring for Operation
ACE-3105, ACE-3205 Ver. 5.2
Setting the Default Gateway
One of the router interfaces should be set as the default gateway.
³
To set the default gateway:
•
From the (see
), select Default Gateway.
The Default Gateway menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> Applications> Router> Default gateway
1. Gateway interface number ... (-)
2. Gateway IP address ... (0.0.0.0)
>
Please select item <1 to 2>
ESC-previous menu; !-main menu; &-exit
Figure
4-66. Default Gateway Menu
Table
4-59. Default Gateway Parameters
Parameter Description
Possible
Values
Gateway
interface
number
ID number of a defined router interface
that should be used as the default gateway.
Note: Cannot be changed dynamically (on-
the-fly).
Any previously
configured router
interface
Gateway IP
address
The gateway IP address for routing the
outgoing IP packets. Visible only when the
gateway interface number is configured over
an Ethernet port.
Note:
•
The default gateway IP address must be
on the same subnet as one of the router
interface indicated above
•
The gateway address should not be
identical to one of the host IP address.
•
Multicast, broadcast, all ones and all
zeros are not allowed.
•
Address parts that are not subnet cannot
be all zeros or all ones.
•
Cannot be changed dynamically (on-the-
fly).
0.0.0.0 –
255.255.255.255
You can delete the current default gateway setting by pressing R. It cannot be
deleted, however, if it is used as a route of an existing peer.
Note