Chapter
4 Configuration
Installation and Operation Manual
4-108 Configuring for Operation
ACE-3105, ACE-3205 Ver. 5.2
Configuring the General PW Parameters
Each individual pseudowire connection has general parameters that must be
defined separately.
³
To access the general pseudowire parameters:
•
From the PW menu, select General Parameters.
The PW General Parameters menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> Applications> Multiservice over PSN> PW > General
parameters
PW number ... (1)
PW name ... (PW-1)
1. PW type > (Basic CES PSN)
2. PW sub type ... (Clock distribution)
3. PSN type ... (MPLSoIP)
4. Peer number ... (2)
5. Provisioning mode ... (Manual)
6. PW ID ... (12)
7. Out PW label ... (0)
8. In PW label ... (0)
9. Control Word > (Enable)
10. Sequence number ... (Enable)
11. TX queue ... (4-Low)
12. OAM mode > (VCCV-BFD)
13. Detection multiplier ... (2)
14. Min TX interval (usec) ... (100000)
15. Max RX interval (usec) ... (100000)
>
Please select item <1 to 15>
ESC-previous menu; !-main menu; &-exit
Figure
4-78. Pseudowire General Parameters Menu