Chapter
6 Monitoring and Diagnostics
Installation and Operation Manual
6-72
Handling Alarms and Traps
ACE-3105, ACE-3205 Ver. 5.2
Viewing and Masking Alarm Traps
The trap masking configuration menu is located under: Configuration> System>
Management> Manager list> Traps. For more information, refer to
Configuring
Alarm Traps
in Chapter 4.
List of Alarm Traps
Refer to
for all the alarm traps that are implemented in
ACE-3105, ACE-3205.
Table
6-60. List of Alarm Traps
Number Trap
Name
1.
Cold Start
2.
Agent Status Changed
3.
TFTP status changed
4.
Authentication failure
5.
Power failure
6.
Fan failure
7.
Port status change – for SFP
8.
Redundancy status*
9.
Link down – only for ETH ports
10.
Link up – only for ETH ports
11.
Loss Of Signal (LOS Physical Layer)*
12.
Loss Of Frame (LOF Physical Layer)*
13.
Loss Of ATM Cell Delineation (LCD ATM Layer)*
14.
VP loopback failed (Fault Management in ATM layer)*
15.
VP continuity loss (Fault Management in ATM layer)*
16.
VP AIS Alarm Received (Fault Management in ATM layer)*
17.
VP RDI Received (Fault Management in ATM layer)*
18.
VC loopback failed (Fault Management in ATM layer)*
19.
VC continuity loss (Fault Management in ATM layer)*
20.
VC AIS Alarm Received (Fault Management in ATM layer)*
21.
VC RDI Received (Fault Management in ATM layer)*
22.
IMA Group Status Change
23.
Station clock failure*
24.
Clock recovery stage
25.
PW up
