Chapter
2 Installation and Setup
Installation and Operation Manual
2-2 Required
Equipment
ACE-3105, ACE-3205 Ver. 5.2
Since ACE-3105, ACE-3205 units or other devices in use generate their own heat,
the actual ambient temperature may be higher than the room temperature if
several units are placed next to or on top of each other (such placement is
allowed as long as the ambient temperature does not exceed the specified
above).
2.2
Package Contents
The ACE-3105, ACE-3205 package contains the following items:
•
ACE-3105 or CE-3205 unit
•
AC power cord or DC connection kit
•
CBL-RJ45/2BNC/E1/X – adapter cable for unbalanced E1 interface (if ordered)
•
RM-34 (for ACE-3205, supplied) or RM-35 (for ACE-3105, if ordered) rack
mounting kit
•
WM-34 (for ACE-3205) or WM-35 (for ACE-3105) – hardware kit for mounting
one unit on a wall (if ordered)
•
Small Form-Factor Pluggable (SFP) modules (if ordered)
•
Technical documentation CD – Contains the relevant PDF documents for
ACE-3105, ACE-3205, including the DC power connection supplements and
the relevant RADview manuals.
2.3
Required Equipment
ACE-3105, ACE-3205 is a standalone unit, designed for desktop or bench
installation and is delivered fully assembled. No provisions are made for bolting
the unit to a tabletop.
Mounting ACE-3105, ACE-3205 in a 19-inch rack, however, requires a 3 mm
Phillips screwdriver and an RM-34 or RM-35 kit (RM-34 for ACE-3205; RM-35 for
ACE-3105; two ACE-3105 units can be installed on a single rack). For the rack
installation instructions, refer to the Rack Mounting Kit for 19-inch Racks
guide
that comes with the RM kit.
Power Cable
AC-powered ACE-3105, ACE-3205 is equipped with an appropriate power cord
(country or region dependent) to be connected from the mains to the power
socket of the hot-swappable power unit (accessible from the front panel).
DC-powered ACE-3105, ACE-3205 is equipped with an appropriate DC connection
kit, which should be used for preparing the DC cable connection.
Note
