For Immediate Assistance • 1-800-325-6138 • 24/7 TECHNICAL SUPPORT
Note: On Pot Style Flywheel,
drive pins must be replaced
with every clutch. If they are
not replaced and made square,
the center plate can bind up.
CLUTCH INSTALLATION TOOL KIT
TOOL KIT ATK-200
This clutch installation tool kit was designed with the mechanic in mind.
Take the guesswork out of your next install!
Flywheel Gauge
This gauge is for measuring the flywheel after it has been resurfaced to ensure proper clutch
operation and longevity. The gauge is designed to measure 3 dimensions:
1. You must have a minimum of 5/16” distance
from the friction surface of your flywheel to
the top of the bolt head that holds the flywheel
to the crankshaft. If it is less than 5/16”, you
need a NEW flywheel.
If this dimension is less
than 5/16” the dampener of the clutch disc will
hit the crank bolts and cause failure.
2. Clutch centering lip cannot be greater than 3/16”
deep. This dimension increases as the flywheel
wears or is ground for resurfacing.
If it is greater than
3/16” the clutch will not bolt tight to flywheel.
3. For correct clutch operation on a 14” pot style flywheel
this dimension must be 2.937”. When resurfacing
these flywheels you must remove the same amount
from the clutch mounting surface as you do the friction
surface to maintain 2.937”.
