ACE-MFG.COM • customerservice@ace-mfg.com
CLUTCH INSTALLATION TOOL KIT
Disc Alignment Shaft
This shaft is to aid in proper alignment of the clutch disc and clutch assembly at installation.
Referencing Fig. 1, place the alignment shaft in the pilot bearing and install correct clutch
disc oriented the proper way. Place the center plate in flywheel housing, making sure a
lug is between the clutch alignment pins. Install remaining clutch disc oriented the proper
way. Install clutch cover assembly over alignment shaft and utilizing clutch alignment pins,
position the center plate in the cover.
Clutch Adjustment Gauge
This gauge is for measuring the dimensions between the clutch release bearing and the
clutch brake (1/2"), and the dimension between the clutch fork (when using mechanical
linkage )and release bearing wear pads (1/8"). These measurements ensure proper clutch
adjustment.
Fig. 1
Clutch Alignment Pins
These pins are to aid in the
installation of the clutch cover
assembly to the flywheel.
Install these pins in the top two
clutch mounting bolt holes.
Shaft Removal Tool
Once clutch is installed to the flywheel and the other mounting bolts are
installed, remove pins and install the last two mounting bolts. Tighten to
proper torque.
Once the clutch is properly bolted to the flywheel and the shipping
blocks have been removed, install T-handle (Fig. 2) in the end of the disc
alignment shaft (Fig. 3) and remove from clutch assembly.
Fig. 3