UNIT INSTALLATION
Important Installation Note:
It is highly recommend to have a licensed refrigeration
technician (or a licensed electrician) properly install your
Commercial
Refrigeration Equipment
and use the unit as it is intended for, in a
commercial location and for commercial purpose only.
Prior to installation, all the packing materials (such as cardboards,
protective foams, plastic covers and tapes) should be removed.
Inspect the unit for any concealed damages prior to installation and
contact the manufacturer or the authorized dealer in case of any
interior or exterior damages.
To insure proper operations and performance the unit should be
installed on a flat and level floor. Use a leveling device to make sure
the unit is level front to back and left to right, including interior floor.
Kegerator unit should be placed and installed in a well-ventilated area
with at least 2 inches of space between the surrounding walls and the
unit exterior walls, to insure proper air circulation.
To avoid a decrease in cooling efficiency, the unit should be placed
far from any heating source and away from direct sunlight.
Under extreme heat conditions, over 100°F (38°C), placing an
external blower fan near the unit, for additional air circulation through
compressor compartment, is recommended.
Install the unit indoor and in a dry (low humidity) place to prevent rust
forming on the metal parts and the exterior panels, high humidity also
cause damage to electrical components and wiring.
