Acecad DigiMemo 692, User Manual

2 

Pen Cap 

Ink Cartridge 

Pen Clip

Front Section 

Barrel 

Barrel Cover

Rear Section

(-)

 Cap

(+)

 Can

Battery 
Compartment 

Note! 

Do not mix new and used batteries. 

Note!  With continuous use of the digital pad, four AAA alkaline batteries will last 

approximately 100 hours.   

Note!  The battery compartment cover has a safe function. When the battery 

compartment cover is not completely closed or is opened, the digital pad can 
not be turned on to capture and store your handwriting.   

Installing the Battery into the Digital Inking Pen 

Unscrew the barrel cover counterclockwise from the barrel of 
the pen. Take out the button cell battery (SR626SW, 377 or 
IEC-SR66) that is included in the package of the DigiMemo 
A502/692. Insert the battery into the battery compartment with 
the negative (-) cap facing the battery compartment. Screw 
the barrel cover clockwise onto the barrel until tight. 

Note!  Incorrect battery installation will result in the 

malfunction of the digital inking pen. 

Note! 

The battery of the digital inking 
pen will last approximately 14 months.   

Note! 

The front or rear section of the pen can hold the 
pen cap. 

Note! 

You can attach some cord or accessory to the pen 
through the two holes on the pen end. 

Note! 

You can clip the pen to the pad by using the pen 
clip to clip to the right or left pen holder of the pad. 

Putting a Notepad or Paper on the Digital Pad 

To hold a notepad on the pad, slide the backing of the 
notepad down into the notepad slot on the pad as far as 
the backing can possibly go.   

Note!  The size of the notepad holder on the pad is 

6.0" x 9.1" (153 mm x 232 mm). Your notepad 
size can not be over this size. 

You can directly put a few sheets of paper on the writing area of the pad for your writing. 
You also can use the paper clip to clip a few sheets of paper on the pad for your writing. 

Pen End 

Paper Clip