-
5-
NOTICE
1.
If somehow you cannot get video output, please try to adjust EDID dip switch to
“
[pin1,
pin2]=[
↓
-
↑
-]
”
for trouble shooting. If
“
[pin1, pin2]=[
↓
-
↑
-]
”
still cannot work, please
switch to
“
[pin1, pin2]=[
↓
-
↓
]
”
to learn the EDID from output 1 to customize the EDID
information.
(Please note that the display with lowest resolution must be connected to output 1)
Select
to [pin1, pin2]=[
↓
-
↓
] - Learning EDID from output 1
(1)
Set the rotary switch to
↓
-
↓
]
(2)
Power on the device
(3)
It will automatically learn EDID from output 1
If you would like to keep Ultra HD video on display and go with the legacy HDMI Amplifiers (Full HD) in
the environment, please
↑
-
↓
Select to
[pin1, pin2]=[
↑
-
↓
]
AVR MODE
(1)
[pin1, pin2]=
[
↑
-
↓
]
”
(2)
Power on the device
[NOTE]
Please power cycle the device after re-setting dip switch
.
2.
Firmware update is proceeded through Micro-USB.
(1)
Save the firmware file (.bin) & software in the same folder.
(2)
Connect the Micro-USB cable between PC and device
(3)
Open firmware update software and then device will start to update firmware automatically.
(4)
After
automatically.
(5)
Power cycle the device
