System Introduction
1-21
Table 1-32
Hibernation Mode Conditions and Descriptions
Condition
Description
The condition to
enter Hibernation
Mode
There are two necessary conditions for the computer to enter standby mode:
•
Heuristic Power Management Mode must be set to [ENABLED].
•
The hibernation file created by Sleep Manager must be present and valid.
In this situation, the following are ways to enter hibernation mode:
•
Pressing the sleep hot key Fn-F7
•
“Hard Disk Drive” is not [Disabled] in System Security of BIOS SETUP.
•
“Hard Disk 0” is not [None] in Basic System Configuration of BIOS SETUP.
•
If the waiting time determined by the computer’s HPM unit elapses without any
system activity.
•
If a battery low condition takes place, the computer enters hibernation mode in
about three minutes. The Sleep Upon Battery-low parameter in Setup must be set
to [ENABLED].
•
Invoked by the operating system power saving modes
The condition of
Hibernation Mode
•
Except the RTC, KB controller and power switch, all the system components are
off.
The condition back
to On Mode
•
Pressing the power switch.
•
Resume Timer matched
DISPLAY STANDBY MODE
Screen activity is determined by the keyboard, the built-in touchpad, and an external PS/2 pointing
device. If these devices are idle for the period determined by the computer’s HPM unit, the display
shuts off until you press a key or move the touchpad or external mouse.
Table 1-33
Display Standby Mode Conditions and Descriptions
Condition
Description
The condition to enter
Display Standby Mode
•
Pointing device is idle until Display Standby Timer times-out or LCD cover is
closed.
The condition of
Display Standby Mode
•
All the system components are on except LCD backlight and CRT
horizontal frequency output (if CRT is connected)
The condition back to
On Mode
•
Any keystroke (Internal KB or External KB)
•
Pointing device activity
The VGA BIOS should support DPMS (Desktop Power Management System) for the
standby and hibernation mode function call. When the Display Standby Timer
expires, the system BIOS will execute the DPMS service routines.
HARD DISK STANDBY MODE
The hard disk enters standby mode when there are no disk read/write operations within the period of
time determined by the computer’s HPM unit. In this state, the power supplied to the hard disk is
reduced to a minimum. The hard disk returns to normal once the computer accesses it.
Summary of Contents for 365 Series
