3-10
Service Guide
Table 3-5
Power Management Settings Parameters
Parameter
Description
Setting or Format
Modem Ring Resume
On Indicator
When enabled, and an incoming modem ring is
detected, the computer wakes up from standby mode.
When the computer is off or in hibernation mode, the
computer will not resume on a modem ring.
Enabled
Disabled
Battery-low Warning
Beep
Enables or disables warning beeps during a battery-low
condition.
Enabled
Disabled
Sleep Upon Battery-low
Enables or disables the sleep function (hibernation or
standby) during a battery-low condition.
When the computer is running very low on battery
power, the computer will disregard the system sleep
state setting and enter hibernation mode if Sleep
Manager is installed and the hibernation file is valid.
Enabled
Disabled
Pressing Fn-F6 during normal computer operation (after POST) also brings up the power
management screen. An additional page, shown below, is added to this function which appears
only via Fn-F6.
System Information Reference
Serial Number
: 11111111117
System BIOS Version : V3.0 R01-A0-EN
BIOS Release Date
: 2/14/97
VGA BIOS Version
: 0.2.5 R01-F0
Processor
: Pentium
Internal Cache
: 16KB, Enabled
Processor Speed
: 150 MHz
External Cache : 256KB, Enabled
Total Memory
: 16 MB
Pointing Device : Detected
Video Memory
: 2 MB
Serial Port
: 3F8h, IRQ4
Floppy Drive A
: 1.44 MB
Irda FIR
: 2F8h, IRQ3, DMA3
Floppy Drive B
: None
Internal Modem : 3E8h, IRQ11
Hard Disk
: 1033 MB
Parallel Port
: 378h, IRQ7
CD ROM
: Installed
Operation Mode : Bi-directional
CD ROM Bootable
: Enabled
System Boot Drive
: Drive A Then C
Esc=Exit
The System Information Reference screen gives a summary of your computer’s BIOS information.
These items are easy to understand and are self-explanatory.
Note: The Serial Number and BIOS Versions are important information about your
computer. If you experience computer problems, this data helps our service
personnel know more about your computer.
Summary of Contents for 390 Series
