100
Chapter 3
9.
Detach the acetic tapes holding the FPC cable from the LCD panel and detach the acetic tape securing
the FPC connector.
10. Disconnect the FPC cable from the LCD panel.
Removing the LCD Brackets
1.
See “Removing the Battery Pack” on page 62.
2.
See “Removing the Lower Cover” on page 64.
3.
See “Removing the WLAN Board Modules” on page 68.
4.
See “Removing the Middle Cover and the Power Board” on page 78.
5.
See “Removing the LCD Module” on page 81.
6.
See “Removing the LCD Bezel” on page 97.
7.
See “Removing the LCD module with the Brackets” on page 98.
8.
See “Removing the Inverter Board and FPC Cable” on page 99.
9.
Remove the four screws (F) securing the left and right LCD brackets to remove the brackets.
Step
Size (Quantity)
Color
Torque
1~4
M2 x L3 (4)
Silver
1.6 kgf-cm
SG_Tangiz.book Page 100 Tuesday, July 10, 2007 11:01 AM
Summary of Contents for 7720
