4 BIOS setup
110
To set a Supervisor/User password
1
Use the up/down keys to highlight a password parameter
(Supervisor Password or User Password) then press
Enter
.
A password box will appear.
2
Type a password then press
Enter
.
The password may consist of up to six alphanumeric characters
(A-Z, a-z, 0-9).
3
Retype the password to verify the first entry then press
Enter
again.
After setting the password, the system automatically sets the
chosen password parameter to Installed.
To change the Supervisor/User password
1
Use the up/down keys to highlight either change password
parameters (Change Supervisor Password or Change User
Password) then press
Enter
.
2
Type the original password then press
Enter
.
3
Type a new password then press
Enter
.
4
Retype the password to verify the first entry then press
Enter
again.
To remove the User password
1
Use the up/down keys to highlight the Clear User Password
parameter then press
Enter
.
Password on
boot
Select Enabled to activate security
check during POST.
Disabled
Enabled
Fixed disk
boot sector
Sets the control level of the hard disk
drive.
Normal
Write Protect
Diskette access
Sets the control level of the floppy
drive.
Supervisor
Normal
Parameter
Description
Option
Summary of Contents for Altos G5350
