3 System upgrade
48
Upgrading the processor
This section explains the procedures for removing and installing the
processor and heat sink fan (HSF) assembly.
Processor configuration guidelines
The mainboard has two Socket F (1207-pin) processor sockets
supporting Dual-Core or Quad-Core AMD Opteron™ processors. You
have the option to upgrade the default processor or install a second
one for a dual-processor configuration.
Observe the following guidelines when replacing or installing a
processor.
•
The CPU 1 socket must always be populated. If no processor is
installed in this socket, the system will fail to boot.
•
Before removing a processor, make sure to back up all important
system files.
•
When installing a second processor, make sure it has same
stepping and frequency specifications as the default processor.
•
Handle the processor and the HSF assembly carefully. Damage to
either may prevent the system from functioning properly.
To upgrade the default processor:
1
Perform the pre-installation instructions described on page 35.
2
Lay the server on its side (components showing).
Summary of Contents for Altos G5450 Series
