3 System upgrade
58
Installing an expansion card
This section explains how to install an expansion card.
I/O interface
Altos G5450 has five PCI bus slots:
•
PCI1--32bit/ 33MHz PCI slot
•
PCI2--32bit/ 33MHz PCI slot
•
PCIE_1--PCI Express x16 slot (w/ x8 throughput)
•
PCIE_2--PCI Express x8 slot (w/
x4 throughput)
•
PCIE_3--PCI Express x16 slot (w/
x16 throughput)
To install an expansion card:
1
Perform the pre-installation instructions described on page 35.
2
If necessary, remove any cables that prevent access to the
processor sockets.
3
Locate an empty expansion slot that is compatible with the
specification of the card you intend to install.
4
Install the expansion card.
(1) Press the release latch of the slot cover opposite the selected
expansion slot.
(2) Pull out the slot cover and store it for reassembly later.
Summary of Contents for Altos G5450 Series
