5 Troubleshooting
128
•
Make sure the FDD and signal cables are properly connected.
•
Check that relevant switches and jumpers for the FDD are set
correctly.
•
Check that FDD is properly configured.
•
If you are using the onboard diskette controller, use BIOS setup on
page 81 to make sure that onboard “Floppy A” is set to
1.44 MB,
3.5-inch
.
HDD activity indicator does not light.
If you have installed one or more hard drives in your system, do the
following:
•
Make sure the power and signal cables are connected correctly.
•
Check that relevant switches and jumpers on the hard drive and
SCSI or SATA backplane are set correctly.
CD drive activity indicator does not light.
Do the following:
•
Make sure the power and signal cables are properly installed.
•
Check that relevant switched and jumpers on the drive are set
correctly.
•
Check that drive is properly configured.
•
Check that onboard IDE controller is enabled in the BIOS setup.
CD tray cannot be ejected.
Do the following:
•
Insert the tip of a paperclip into the small hole on the CD drive.
Slowly pull the tray out from the drive until the tray is fully
extended then remove the disc.
Summary of Contents for Altos G710
