v
Important safety information
Only a technically qualified person shall access, integrate, configure, and service
this product.
Intended application uses
This product was evaluated as an Information Technology Equipment (ITE),
which may be installed in offices, schools, computer rooms, and similar
commercial type locations. The suitability of this product for other Product
Categories and Environments (such as medical, industrial, alarm systems, and
test equipment), other than as an ITE application, may require further
evaluation.
Checking the power cords
Warning! To avoid electrical shock, do not attempt to
modify or use the supplied AC power cord(s), if they are
not the exact type required.
If a power cord(s) supplied is not compatible with the AC wall outlet in your
region, get one that meets the following criteria:
•
The power cord must be properly rated for the AC voltage in your region.
•
The power cord plug cap must have an electrical current rating that is at
least 125% of the electrical current rating of the product.
•
The power cord plug cap that plugs into the wall socket-outlet must have a
grounding-type male plug designed for use in your region.
•
The power cord must have safety certifications for your region, and shall
be marked with the certification markings.
•
The power cord plug cap that plugs into the AC receptacle on the power
supply must be an IEC 320, sheet C13, type female connector.
•
In Europe, the power cord must be less than 4.5 meters (14.76 feet) long,
and it must be flexible <HAR> (harmonized) or VDE certified cordage to
comply with the chassis' safety certifications.
•
The power supply cord(s) is the main disconnect device to AC power. The
socket outlet(s) shall be near the equipment and shall be readily accessible
for disconnection.
AA G900 ug - EN.book Page v Wednesday, September 25, 2002 5:23 PM
Summary of Contents for Altos G900
