151
•
Is the drive properly configured?
Cannot Connect to a Server
•
Make sure the network cable is securely attached to the correct connector
at the system back panel.
•
Try a different network cable.
•
Make sure you are using the correct and the current drivers.
•
Make sure the driver is loaded and the protocols are bound.
•
Make sure the hub port is configured for the same duplex mode as the
network controller.
•
Make sure the correct networking software is installed.
•
If you are directly connecting two servers (without a hub), you will need a
crossover cable.
•
Check the network controller LEDs next to the NIC connectors.
Problems with Network
The server hangs when the drivers are loaded.
•
Certain drivers may require interrupts that are not shared with other PCI
drivers. For these drivers, it may be necessary to alter settings so that
interrupts are not shared. See the documentation that came with your PCI
card(s) for information on changing interrupts.
Diagnostics pass but the connection fails.
•
Make sure the network cable is securely attached.
•
Make sure you specify the correct frame type in your NET.CFG file.
The controller stopped working when an add-in adapter was installed.
•
Make sure the cable is connected to the port from the onboard network
controller.
•
Make sure your BIOS is current.
•
Make sure the other adapter supports shared interrupts. Make sure your
operating system supports shared interrupts.
•
Try reseating the add-in adapter.
The add-in adapter stopped working without apparent cause.
•
Try reseating the adapter first; then try a different slot if necessary.
•
The network driver files may be corrupt or deleted. Delete and then
reinstall the drivers.
•
Run the diagnostics.
Summary of Contents for Altos R510
