69
8
Disconnect the data cable from the rear of the DVD/CD-RW or CD-
ROM drive.
9
Remove the two screws at the rear of the DVD/CD-RW or CD-ROM
drive to disconnect the interposer board.
10 Store the screw and interposer board for future use. Suggestion:
tape the screw to the drive carrier.
11 Slide the empty drive carrier into the chassis until it clicks into
place.
12 Install the chassis cover. For instructions, see
“Installing the Chassis
Cover.”
13 (Optional) Install the front bezel. For instructions, see
“Removing
and Installing the Front Bezel.”
14 Plug all peripheral devices and the AC power cable back into the
server.
Installing DVD/CD-RW or CD-ROM Drive into
Slimline Bay (No Backplane Installed)
NOTE: The carrier for the slimline DVD/CD-RW drive / CD-ROM
drive was pre-installed in the slimline drive bay of your Altos R510
Server Chassis. The interposer board and floppy drive power
adapter cable used in these instructions was sent to you with your
fixed drive kit.
1
Observe the safety and ESD precautions at the beginning of this
book. See
“Safety Information.”
2
Power down the server and unplug all peripheral devices and the
AC power cable.
3
Remove the chassis cover. For instructions, see
“Removing the
Chassis Cover.”
4
Remove the front bezel if it is installed. For instructions, see
“Removing and Installing the Front Bezel.”
5
Push in on the blue lever at the rear of the DVD/CD-RW or CD-ROM
drive carrier and push the carrier out through the front of the
chassis.
Summary of Contents for Altos R510
