77
8
Insert the add-in card until it seats in riser card connector. Make
sure the bracket inserts into the matching slot. See letter “C”.
9
Close the retention clip. See letter “A” in the figure.
10 Position the riser assembly over the PCI sockets on the server board
(see letter “A” in the figure below), lining up the four hooks at the
rear of the riser assembly (see letter “B”) with the four slots in the
rear of the chassis (see letter “C”).
11 Push the riser assembly down until the assembly is securely seated
(as shown in the diagram on page 74).
12 Install the chassis cover. For instructions, see
“Installing the Chassis
Cover.”
13 Plug all peripheral devices and the AC power cable back into the
server.
Removing a PCI Add-in Card
1
Observe the safety and ESD precautions at the beginning of this
book. See
“Safety Information.”
2
Power down the server and unplug all peripheral devices and the
AC power cable.
3
Remove the chassis cover. For instructions, see “Removing the
Chassis Cover.”
4
Pull up on the two latches on the riser assembly.
5
Lift the PCI riser assembly from the chassis.
6
Open the PCI retention clip on the PCI riser card assembly.
C
A
B
Summary of Contents for Altos R510
