Securing your computer - 53
Entering passwords
When a password is set, a password prompt appears in the center
of the display screen.
• When the Supervisor Password is set, a prompt appears when
you enter the BIOS utility.
• Type the Supervisor Password and press
Enter
to access the
BIOS utility. If you enter the password incorrectly, a warning
message appears. Try again and press
Enter
.
• When the User Password is set and the password on boot
parameter is enabled, a prompt appears at boot-up.
• Type the User Password and press
Enter
to use the computer. If
you enter the password incorrectly, a warning message
appears. Try again and press
Enter
.
Important
You have three chances to enter a password. If you fail to enter the
password correctly after three tries, the system halts. Press and
hold the power button for four seconds to shut down the computer.
Then turn on the computer again, and try again.
Summary of Contents for AN515-45-R9X1
