System Utilities
2-8
NOTE:
The same procedures apply in setting the user password and HDD password.
When the supervisor password is set, the
Set User Password
and
Password on Boot
parameters are enabled for users to configure.
Changing a Password
Perform the following to change a password:
NOTE:
Below are the procedures for changing the supervisor password. The same procedures apply
in changing the user and HDD passwords.
1.
Use the
↑
and
↓
keys to highlight the
Set Supervisor Password
parameter and press
Enter. The
Set Supervisor Password
dialog box appears.
Figure 2:6. Set Supervisor Password
2.
Type the current password in the
Enter Current Password
field and press Enter.
3.
Type the new password in the
Enter New Password
field and press Enter.
4.
Retype the new password in the
Confirm New Password
field.
5.
Press Enter. If the passwords match, the
Setup Notice
dialog box appears.
Figure 2:7. Setup Notice
6.
Press Enter to complete the password setting. The computer sets the
Supervisor
Password Is
parameter to
Set
.
7.
Press F10 to save changes and exit BIOS Setup Utility.
Set Supervisor Password
Enter Current Password
[
]
Enter New Password
[
]
Confirm New Password
[
]
Setup Notice
Changes have been saved.
[Continue]
