C
HAPTER
3:
C
ONFIGURATION
17
Chapter 3: Configuration
Initial Configuration
The ARMC/3P’s communication interfaces are all based on TCP/IP. It comes
preconfigured with the IP configuration listed in Table 4 Initial Network Configuration.
Table 4 Initial Network Configuration
Parameter
Value
IP auto configuration
DHCP
IP address
none
Netmask
255.255.255.0
Gateway
none
IP access control
none
Important: If the DHCP connection fails on boot up, the ARMC/3P
will not have an IP adresss.
If this initial configuration does not meet your requirements, the following describes the
initial IP configuration that is necessary to access the ARMC/3P for the first time.
ARMC/3P Psetup Tool
The psetup tool is used to determine the IP address assigned to the ARMC/3P by the
DHCP server or to change the device’s initial network configuration.
Using the Psetup Tool via Graphical User Interface
Connect the ARMC/3P to your computer via local network. Start the psetup tool,
which can be
found
on your ARMC/3P CD, on the computer in which the ARMC/3P
is installed or any other computer which is part of the same local network.
Note: If your network provides a properly configured DHCP server the
ARMC/3P should be automatically assigned an IP address. Please ask your
DHCP admin for the IP address the ARMC/3P got from the DHCP server.
A window opens as seen in Figure 17 (on a Windows OS) and Figure 18 ARMC/3P
Psetup Tool (Linux Version).
Summary of Contents for ARMC_3P
