Chapter 3
Aspire 1800
Aspire 1800 Disassembly Procedure
This section will guide you how to disassemble the system when you need to perform system service.
Please also refer to the disassembly video, if availabled.
CAUTION:
Before you proceeded sure you have turned off the system and all peripherals connected.
Disassemble the Battery and HDD
1.
Press the latch backward to take the battery away from the system.
2.
Then remove the battery pack.
3.
Remove the two screws to release the hard drive door.Then take it away.
4.
With a flat screwdriver to push the HDD outward then pull it out from the system
5.
Remove the two screws located on each side.
6.
Take the Hard disk unit from the carrier.
Disassemble the Wireless
1.
Remove the one screw to release the Wireless door.
2.
Take the wireless door from the system.
3.
Disconnect the Antenna cables from the wireless board.
4.
Push outward the tabs on both side to release the wireless board then pull it out from the system.
Summary of Contents for Aspire 1800
