Chapter 2
41
Advanced
The Advanced screen contains parameters involving your hardware devices. It also provides advanced
settings of the system.
FIR Ports
Configure the system’s infrared port using options:
Disabled
and Enabled.
The table below describes the parameters in the screen. Settings in
boldface
are the default and suggested
parameter settings.
Description
Option
FIR I/O Settings
Sets the base I/O address and IRQ for
Infrared port.
COM1, 3F8, IRQ4/ COM2,
2F8, IRQ3/ COM3, 3E8,
IRQ4/
COM4, 2E8, IRQ3
DMA Setting for Fast
IR
Sets a DMA channel for the printer to
operate in ECP mode. This parameter is
enabled only if Mode is set to ECP.
DMA1, DMA2,
DMA3
,
Mode Setting
Normak (16550), IrDA
(HPSIR), ASK IR,
FAST IR
ʳ ʳ
˲ʳ ʳ
ԩʳ
ԩʳ
ԩ
Insyde Software SCU May 20, 2003 5:40:09
Main
Advanced
Security Boot
Exit
---------------------------------FIR Ports--------------------------------
-----FIR I/O settings---
-Mode Setting for IRDA-
\
FIR Ports
( ) Disabled
( ) Normal (16550)
( ) COM1,3F8,IRQ4
( ) IrDA (HPSIR)
LPT Port
( ) COM2,2F8,IRQ3
( ) ASK IR
( ) COM3,3E8,IRQ4
(
Ԧ
) FAST IR
ԩ
Legacy USB
(
Ԧ
) COM4,2E8,IRQ3
--DMA Setting For Fast IR--
( ) DMA1
( ) DMA2
( ) DMA3
OK
Cancel
<Tab> <Right> <Left> for block select. <Up> <Down> for item select.
< Enter> for accept. <Cancel> <Esc> for reject. <Alt> activates accelerators.
<Space> for Enable or Disable.
